Cub Cadet Pro Z 900 Serie Manuel De L'opérateur page 13

T1
U
F
G
Z
J
NOTE: This Operator's Manual covers several models. Mower features may vary by
model. Not all features in this manual are applicable to all mower models and the
mower depicted may differ from yours.
NOTE: All references in this manual to the left or right side and front or back of the
machine are from the operating position only. Exceptions, if any, will be specified.
A. TRANSMISSION BYPASS LEVER/RODS
WARNING
Do not tow the mower, even with the bypass valves engaged.
Serious transmission damage will result from doing so.
1. Parker Transmission (if equipped) - The transmission bypass lever
is located next to the LH console to the left of the operator's seat.
When engaged the valves open a bypass within the hydrostatic
transmissions. Refer to the Set-up section for instructions on using
the bypass feature.
S
†
†
†
†
AA1
OPERATION
H I
AA2
Y AA1
† †
Figure 22
2. Hydro-Gear Transmission (if equipped) -
The transmission bypass rods (one for each RH
and LH transmission) are located on the rear of
the mower, below the engine. When engaged,
the two rods open a bypass within the hydrostatic transmissions, which allows
the mower to be pushed short distances by hand. Refer to the Set-up section
for additional instructions.
B. IGNITION SWITCH
The ignition switch is located on the RH console to the rear of the throttle control.
The ignition switch has three positions as follows:
OFF/STOP — The engine and electrical system are turned off.
ON — The mower electrical system is energized.
START — The starter motor will turn over the engine. Release the key
immediately when the engine starts.
NOTE: To prevent accidental starting and/or battery discharge, remove the key from
the ignition switch when the mower is not in use.
13
W
†
Y E †
B
AC †
D
†
AD †
C
T2 †
AB
X
Z
J
if equipped
†