Publicité
Les langues disponibles
Les langues disponibles
43. THE MACHINE DOES NOT START
1.
Make sure that the key switch is turned to "I" or "II", depending on the type of power source you
want to use.
2.
Make sure the battery connector is connected to the connector of the machine system.
3.
Check that batteries are charged.
4.
Check there is fuel in the motor tank (Hybrid versions).
44. THE ENDOTHERMIC ENGINE DOES NOT START
WARNING: If the combustion engine does not start, check the diagnostics in the
motor user manual (the booklet supplied with the machine itself)
45. THE MACHINE DOES NOT CLEAN WELL
1.
Check the state of wear and tear of the brushes and, if necessary, replace them. The brushes
should be changed when the bristles are about 10mm long. To replace them, see "CENTRAL
BRUSH REPLACEMENT", or "SIDE BRUSH REPLACEMENT". Working with over-worn brushes
may cause damage to the floor.
2.
Use a different kind of brush to the one fitted as standard. For cleaning floors where the dirt is
particularly resistant, we recommend the use of special brushes supplied upon request and
according to needs (see "CHOOSING AND USING THE BRUSHES").
3.
The side brush is worn, to adjust it see "SIDE BRUSH ADJUSTMENT".
4.
The debris hopper is full, empty it completely.
46. THE MACHINE LIFTS DUST DURING OPERATION
1.
The flaps that ensure efficient vacuum action are worn: replace them.
2.
The front flap is broken and the machine projected heavy dirty bodies forward: replace them.
3.
The filter is blocked: clean the filter thoroughly.
4.
Check the central brush is correctly assembled
5.
The debris hopper position is not correct
47. EXCESSIVE OR ALTERED NOISE OF THE CENTRAL BRUSH
1.
Material wrapped around the brush: remove it.
48. EXCESSIVE OR ALTERED NOISE OF THE SIDE BRUSH
1.
Material wrapped around the brush: remove it.
TROUBLESHOOTING
45
Publicité
