Publicité
Les langues disponibles
Les langues disponibles
24. BLINKING LIGHT (OPTIONAL)
The machine can be equipped with a blinking light that turns on automatically when the key in the main
switch is turned on.
25. FILLING THE FUEL TANK (HYBRID VERSIONS)
The machine is supplied without any fuel in the tank of the endothermic engine. To fill the tank, proceed
as follows:
1.
Make sure the electric brake is engaged, otherwise engage it using the lever (1) located at the left
rear of the machine (working direction).
2.
Check the main switch (2) is in the "0" position, if this is not the case, turn the key by a quarter of a
turn to the left, and remove the key from the instrument panel.
3.
Grasp the handle located on the side of the operator seat unit.
4.
Lift the operator seat unit until the safety clamp (3) is hooked.
5.
With regard to the safe filling of the combustion engine fuel tank, you must scrupulously observe
the indications given in the combustion engine user manual (supplied with the machine).
WARNING: The machine does not have a fuel level indicator, so you must always
check the level before using it.
WARNING: Gasoline is highly inflammable and may explode.
WARNING: Top up the fuel in a well-ventilated area, with the motor switched off.
Do not smoke or take any unprotected flames or sparks near the motor while it is
being filled, or in the area where the gasoline is stored.
WARNING: During the filling operation, be careful not to spill the fuel. Spilt fuel or
fuel vapours could ignite. If any fuel is accidentally spilt, remove it thoroughly
before switching on the motor.
26. HEADLIGHTS
The machine has headlights that turn on automatically when the main switch is turned to "I" or "II".
MACHINE PREPARATION
22
Publicité
