Publicité
Les langues disponibles
Les langues disponibles
27. PREPARING TO WORK (B VERSIONS)
Before beginning to work, it is necessary to:
1.
Ensure that the debris hopper is empty, otherwise empty it completely (see paragraph "EMPTYING
THE DEBIT HOPPER").
2.
Check that the condition of the central brush is suitable for the work, otherwise arrange for its
maintenance (see paragraph "CLEANING THE BRUSH CENTRAL" or "CENTRAL BRUSH
REPLACEMENT").
3.
Check that the condition of the side brush (version 1SL or brushes version 2SL) is suitable for the
work, otherwise arrange for their maintenance (see paragraph "CLEANING THE SIDE BRUSH" or
"SIDE BRUSH REPLACEMENT").
4.
Make sure the electric brake is engaged, otherwise engage it using the lever (1) located at the left
rear of the machine (working direction).
5.
Check the main switch (2) is in the "0" position, if this is not the case, turn the key by a quarter of a
turn to the left, and remove the key from the instrument panel.
6.
Make sure the emergency switch is in the OFF position.
7.
Grasp the handle located on the side of the operator seat unit.
8.
Lift the operator seat unit until the safety clamp (3) is hooked.
9.
Connect the machine connector (4) to the battery connector (5).
10. Grasp of the handle located on the side of the operator seat unit and lower the seat unit until it is in
the working position.
PREPARING TO WORK
23
4
5
Publicité
