Publicité
Les langues disponibles
Les langues disponibles
3.
Grasp the handle located on the side of the operator seat unit.
4.
Lift the operator seat unit until the safety clamp (3) is hooked.
WARNING: Before installing the battery, clean the battery compartment with a damp
cloth. Check that the connectors on the cables supplied are functioning correctly.
WARNING: Check that the characteristics of the battery that you are looking to use are
appropriate for the type of work to be performed. Check the battery charge and the
condition of the contacts on the battery.
WARNING: You are advised to only lift and move the batteries with lifting and
transportation means suitable for the specific weight and size.
WARNING: The lifting hooks must not damage the blocks, connectors or cables.
5.
House the batteries in the compartment, positioning the poles "+" and "-" opposite each other.
WARNING: Before inserting the batteries into the machine, remember to cover the
terminals with a little grease to protect them against external corrosion.
WARNING: You are advised to use airtight batteries only, to avoid the leakage of acids!
WARNING: You are advised to always wear protective gloves, to avoid the risk of
serious injury to your hands.
15. FITTING THE BATTERIES INTO THE MACHINE (HYBRID VERSIONS)
The batteries must be housed in the appropriate compartment beneath the seat unit. They should be
handled using lifting equipment that is suitable in terms of both weight and coupling system. They must
also satisfy the requirements of Standard CEI 21-5. The dimensions of the battery compartment are:
10,6 x 14,2 x H9,4 in.
WARNING: For battery maintenance and daily recharging, you must carefully follow the
instructions provided by the manufacturer or retailer. All installation and maintenance
operations must be carried out by specialised personnel.
WARNING: Ensure that you comply with the accident prevention regulations in force in
the country where you work or with DIN EN 50272-3 and DIN EN 50110-1, before any
handling of the batteries.
WARNING: To prevent an accidental short circuit use insulated tools to connect the
batteries, and do not place or drop metal objects on the battery. Remove rings, watches
and any clothing with metal parts that may come into contact with the battery terminals.
To insert the batteries into the compartment proceed as follows:
1.
Make sure the electric brake is engaged, otherwise engage it using the lever (1) located at the left
rear of the machine (working direction).
2.
Check the main switch (2) is in the "0" position, if this is not the case, turn the key by a quarter of a
turn to the left, and remove the key from the instrument panel.
MACHINE PREPARATION
15
Publicité
