Publicité
Les langues disponibles
Les langues disponibles
To connect the battery charger you must:
1.
Move the machine to the place used for maintenance or recharging the batteries.
2.
Make sure the electric brake is engaged, otherwise engage it using the lever (1) located at the left
rear of the machine (working direction).
3.
Check the main switch (2) is in the "0" position, if this is not the case, turn the key by a quarter of a
turn to the left, and remove the key from the instrument panel.
4.
Grasp the handle located on the side of the operator seat unit.
5.
Lift the operator seat unit until the safety clamp (3) is hooked.
WARNING: Park the machine in an place protected from the weather and with suitable
ventilation, and on a flat and level surface; near the machine there must be no objects
that could either damage it, or be damaged through contact with it.
6.
Remove the battery charger cover (4).
7.
Connect the battery charger power cable connector to the socket on the charger itself.Before
inserting the power cable into the socket of the charger, verify that there is no condensate or other
forms of liquids.
8.
Plug the battery charger power cable into the mains socket.
WARNING: Carefully read the use and maintenance manual of the charger that is
delivered inside the bag containing this instruction booklet.
WARNING: Keep the seat unit open for the duration of the battery recharging cycle to
allow gas fumes to escape.
WARNING: The room used to recharge the batteries must be adequately ventilated to
prevent the accumulation of gases that leak from batteries.
9.
When the recharge cycle is complete, disconnect the battery charger cable from the mains.
10. Disconnect the battery charger power cable connector from the socket on the charger itself.
11. Replace the battery charger cover (4).
12. Grasp of the handle located on the side of the operator seat unit and lower the seat unit until it is in
the working position.
WARNING: if the machine's electric system is accidentally powered (by turning the
main switch to "I"), the commands display will show "BATTERY-CHARGER" and no
steering wheel command will function.
WARNING: Always make sure the green LED of the battery charger is on before using
the machine again.
MACHINE PREPARATION
19
4
4
Publicité
