Hillyard TRIDENT SW24R Manuel D'utilisation Et D'entretien page 21

WARNING: Danger of gas exhalation and leakage of corrosive liquids.
WARNING: Danger of fire: do not go near with free flames
10. When the recharge cycle is complete, disconnect the battery charger connector from the external
battery charger.
11. Disconnect the battery charger cable (6) from the battery connector (5).
12. Connect the battery connector (5) to the electric system connector (4).
13. Grasp of the handle located on the side of the operator seat unit and lower the seat unit until it is in
the working position.
21. BATTERY CHARGE LEVEL INDICATOR (B VERSIONS)
On the instrument panel of the machine there is a monitor (1) indicating (amongst other things) the battery
charge status. If the lower line contains ten light indicators, the battery charge level is 100%. If the battery
charge percentage is at 00% and flashing, this means the batteries are discharged.
WARNING: After a few seconds that the battery charge has reached 20%, the central
brush motor, the side brush/es motor, and the vacuum motor will turn off
automatically.With the remaining charge, it is still possible, however, to move the
machine to the location designated for recharging the batteries.
22. HOUR METER
On the machine's instrument panel there is a display (1) indicating the total machine usage time. The top
line shows the hours and minutes of functioning. The flashing ":" symbol Indicates that the hour meter is
counting the machine functioning time.
23. WORKING FORWARD SPEED
This machine is equipped with electronic traction control. To move the machine, after having turned the
key in the "I" position, push the drive pedal (1) adjusting the speed by pressing and releasing the pedal.
The machine will then start moving.
ATTENTION! The machine will not start to move (either forwards or backwards) if the
electrical brake is not engaged. In this case, you will see "ELECTRICAL BRAKE?" on
the command display.
To move the machine backwards, press the button (2) on the instrument panel, then immediately press
the pedal (1). Adjust the speed by altering the degree of pressure on the pedal.
WARNING! The reverse speed is lower than the forward speed to comply with current
health and safety standards.
MACHINE PREPARATION
21