Publicité
Les langues disponibles
Les langues disponibles
33. EMPTYING THE DEBRIS HOPPER
The machine is NOT equipped with a device to warn you when the debris hopper is full, so it is a good
idea to empty it frequently while working. In order to empty the debris hopper, proceed as follows:
1.
Stop the machine close to the place where the debris hopper is emptied.
2.
Lift the central brush by turning the lever (1) anti-clockwise.
3.
Lift the side brush if lowered, by rotating the lever (2) clockwise.
4.
Activate the filter shaker by intermittently pressing the button (3) on the control handlebar, the
vacuum automatically terminates.
WARNING! Do not keep the switch (3) pressed longer than ten seconds; repeat this
operation two or three times.
5.
Rotate the key (4) of the main switch to the "0" position.
6.
Turn the latches (5) in order to release the debris hopper, turn the left latch counterclockwise and the
right latch clockwise.
WARNING: you are advised to always wear protective gloves, to avoid the risk of
serious injury to your hands.
7.
Grasping the handle (6) on the debris hopper, remove it from the machine.
8.
Take the debris hopper to the appropriate location for unloading and empty it.
9.
Grasping the handle (6) on the debris hopper, and assemble it on the machine.
WORK
32
Publicité
