Publicité
Les langues disponibles
Les langues disponibles
20. CONNECTING THE BATTERY CHARGER (HYBRID VERSIONS)
In order not to cause permanent damage to the batteries, it is essential they are fully charged using a
suitable battery charger, after the non-use of the machine for a long period or after ten complete discharge
cycles of the batteries.
WARNING: Never leave the batteries completely discharged, even if the machine is
not being used. Check the battery charger is suitable for the batteries installed, in
terms of both capacity and type.
To connect the battery charger you must:
1.
Move the machine near to the battery charger.
2.
Make sure the electric brake is engaged, otherwise engage it using the lever (1) located at the left
rear of the machine (working direction).
3.
Check the main switch (2) is in the "0" position, if this is not the case, turn the key by a quarter of a
turn to the left, and remove the key from the instrument panel.
4.
Grasp the handle located on the side of the operator seat unit.
5.
Lift the operator seat unit until the safety clamp (3) is hooked.
WARNING: Park the machine in an place protected from the weather and with suitable
ventilation, and on a flat and level surface; near the machine there must be no objects
that could either damage it, or be damaged through contact with it.
6.
Check that the motor switch is in the "0" position, if this is not the case, turn the handle by a quarter
of a turn to the left, and remove the key from the instrument panel.
7.
Disconnect the electric system connector (4) from the battery connector (5)
ATTENTION: this process must be carried out by qualified personnel. An incorrect
connection of the connector may cause problems with machine functioning.
8.
Connect the battery charger cable (6) to the battery connector (5).
WARNING: Keep the seat unit open for the duration of the battery recharging cycle to
allow gas fumes to escape.
WARNING: The room used to recharge the batteries must be adequately ventilated to
prevent the accumulation of gases that leak from batteries.
The coupling connector of the battery charger is supplied inside the bag containing this instruction
booklet, and must be fitted to the battery charger cables as shown in the instructions.
9.
Connect the recently wired cable to the external battery charger.
WARNING: Carefully read the use and maintenance instructions of the battery charger
that is used for charging.
MACHINE PREPARATION
20
Publicité
