Publicité
Les langues disponibles
Les langues disponibles
If the machine does not move and the control display shows "ELECTRO-BRAKE?" the lever on the rear
left of the machine (work direction) is used to activate it.
To lower the right side brush (1SL versions) or both side brushes (2SL versions) simply turn the right (4)
clockwise.
ATTENTION: Use the side brush or brushes (according to machine version) only on
edges, as it is not assisted by the vacuum action.
Deactivate the vacuum motor when you are about to clean wet or damp surfaces, to avoid ruining the
filter. To turn off the vacuum motor, press button (5) on the control handlebar.
WARNING: As soon as button (5) is pressed the control display shows the message
"VACUUM OFF". To re-activate the vacuum, press button (5).
Press the front flap-raiser pedal (6) when working with bulky waste, to allow the central brush to reach and
collect it.
WARNING: Do not hold the pedal for long.
In order to achieve a correct vacuum action, clean the filter every 10 minutes and always before any
discharge of the debris hopper.
To do this, proceed as follows:
1.
Lift the central brush by turning the right lever (2) anti-clockwise.
2.
Lift the side brush if lowered, by rotating the left lever (4) clockwise.
3.
Activate the filter shaker by pressing the button (7) on the control handlebar, the vacuum
automatically terminates.
WARNING: As soon as the central brush is lifted from the ground, the vacuum motor
automatically turns off.
WARNING: As soon as the filter shaker button is pressed, the vacuum motor will turn
off automatically.
Periodically check the filling of the tray and if necessary proceed to empty it. Keep in mind that the weight
of the waste collected is proportional to the specific weight of the material swept. In the case of heavy
material such as sand, earth, gravel, etc. the tray should ideally not be filled more than 70%, otherwise it
may be difficult to empty.
WORK
28
Publicité
