7.
Connect the battery charger cable (6) to the battery connector (5).
WARNING: Keep the seat unit open for the duration of the battery recharging cycle to
allow gas fumes to escape.
WARNING: The room used to recharge the batteries must be adequately ventilated to
prevent the accumulation of gases that leak from batteries.
The coupling connector of the battery charger is supplied inside the bag containing this instruction
booklet, and must be fitted to the battery charger cables as shown in the instructions.
8.
Connect the recently wired cable to the external battery charger.
WARNING: Carefully read the use and maintenance instructions of the battery charger
that is used for charging.
WARNING: Danger of gas exhalation and leakage of corrosive liquids.
WARNING: Danger of fire: do not go near with free flames
9.
When the recharge cycle is complete, disconnect the battery charger connector from the external
battery charger.
10. Disconnect the battery charger cable (6) from the battery connector (5).
11. Connect the battery connector (5) to the electric system connector (4).
12. Grasp of the handle located on the side of the operator seat unit and lower the seat unit until it is in
the working position.
19. BATTERY CHARGER CONNECTION (B VERSION, WITH BC)
In order not to cause permanent damage to the batteries, it is essential to avoid their complete discharge:
arrange the recharge within a few minutes of the switching on of the "discharged batteries" blinking light.
WARNING: Never leave the batteries completely discharged, even if the machine is
not being used. Check the battery charger is suitable for the batteries installed, in
terms of both capacity and type.
MACHINE PREPARATION
18