Hillyard TRIDENT SW24R Manuel D'utilisation Et D'entretien page 34

At the end of work, and before carrying out any type of maintenance, perform the following operations:
1. Stop the machine close to the place where the debris hopper is emptied.
2. Lift the central brush by turning the lever (1) anti-clockwise.
3. Lift the side brush if lowered, by rotating the lever (2) clockwise.
4. Activate the filter shaker by intermittently pressing the button (3) on the control handlebar, the
vacuum automatically terminates.
WARNING! Do not keep the switch (3) pressed longer than ten seconds; repeat this
operation two or three times.
5. Rotate the key (4) of the main switch to the "0" position.
6. Turn the latches (5) in order to release the debris hopper, turn the left latch counterclockwise and the
right latch clockwise.
WARNING: you are advised to always wear protective gloves, to avoid the risk of
serious injury to your hands.
7. Grasping the handle (6) on the debris hopper, remove it from the machine.
8. Take the debris hopper to the appropriate location for unloading and empty it.
WARNING! Periodically check that the sealing ring of the debris hopper and of the
frame, if it is worn or damaged replace it immediately.
9. Grasping the handle (6) on the debris hopper, and assemble it on the machine.
AT THE END OF WORK
34