Hillyard TRIDENT SW24R Manuel D'utilisation Et D'entretien page 24

28. PREPARING TO WORK (HYBRID VERSIONS)
Before beginning to work, it is necessary to:
1. Ensure that the debit hopper is empty, otherwise empty it completely (see paragraph "EMPTYING
THE DEBIT HOPPER").
2. Check that the condition of the central brush is suitable for the work, otherwise arrange for its
maintenance (see paragraph "CLEANING THE BRUSH CENTRAL" or "CENTRAL BRUSH
REPLACEMENT").
3. Check that the condition of the brush (version 1SL or brushes version 2SL) is suitable for the work,
otherwise arrange for their maintenance (see paragraph "CLEANING THE SIDE BRUSH" or "SIDE
BRUSH REPLACEMENT").
4. Make sure the electric brake is engaged, otherwise engage it using the lever (1) located at the left
rear of the machine (working direction).
5. Check the main switch (2) is in the "0" position, if this is not the case, turn the key by a quarter of a
turn to the left, and remove the key from the instrument panel.
6. Make sure the emergency switch is in the OFF position.
7. Grasp the handle located on the side of the operator seat unit.
8. Lift the operator seat unit until the safety clamp (3) is hooked.
9. Connect the machine connector (4) to the battery connector (5).
10. Grasp of the handle located on the side of the operator seat unit and lower the seat unit until it is in
the working position.
11. Perform all the required checks prior to using the combustion engine, following the instructions
given in the user manual of the combustion engine (supplied with the machine).
12. Having completed the controls of the combustion engine, grasp of the handle located on the side of
the operator seat unit and lower the seat unit until it is in the working position.
PREPARING TO WORK
24
4
5