Numatic NX300 Traduction Du Manuel D'utilisation D'origine page 50

Regular Maintenance
!
A
Seperator
1
5
Remove the filter and basket clipped into the separator and flush with clean water (5 & 6).
Replace the filter by first fitting the rear of the filter first then clipping in the front to lock in place (5).
ALWAYS ENSURE THAT THE BATTERY IS REMOVED
PRIOR TO ANY MAINTENANCE OPERATION
B
2
3
Emptying Top Tank
After use, empty waste-water tank using
emptying hose and flush-out with clean
water. (fig.A).
Emptying Bottom Tank
The clean-water tank can be drained via
the red cap fitted to the left hand side
of the machine. There is a sealing bung
beneath the red cap (ensure the sealing
bung is clean) The cap should only be
done up by hand. (fig.B).
Remove the two hoses to disconnect the separator from the
machine (1 & 2).
Remove fixing band holding separator in place (3).
Lift off the separator. The separator has a sealing-rubber which
should be examined at every clean-down (4).
Rinse using clean water.
50
50
EN
!
4
6