Numatic NX300 Traduction Du Manuel D'utilisation D'origine page 56

Changing the Floor-Tool Blades
!
!
1
Unscrew the four knobs securing the
blade holder (Fig.1).
Refitting the floor-tool blades
Floor-tool Overview
1. Retaining knobs x 4
2. Front blade (slotted)
3. Blade carrier
4. Rear blade
5. Floor-tool main body
ALWAYS ENSURE THAT THE BATTERY IS REMOVED
PRIOR TO ANY MAINTENANCE OPERATION
A B
2
Remove the blade holder (Fig.2).
Refit the blade holder, retain using the two outer knobs.
Ensure the slotted blade goes to the front of the floor-tool.
Note: The blades are designed to be reversible, thus extending their useful working life.
Refit the floor-tool using the two central knobs to the floor-tool.
5
4
3
2
1
To change the floor-tool, firstly swing the
floor-tool clear of the machine. Undo the
two floor-tool retaining knobs (Fig.A).
Pull the floor-tool away from the machine
(Fig.B).
Replace the Squeegee blades using
replacement blade set (Fig.3),
fitting the blades on to the moulded
location lugs.
56
56
3
EN
!
!