Numatic NX300 Traduction Du Manuel D'utilisation D'origine page 27

EN
Filling the Clean Water Tank
1
To fill the clean-water tank, remove the filler cap (Fig.1). Fill using a hose or a suitable container (Fig.2).
Use the fill indicator (Fig.3).
NOTE: Great care must be taken to ensure that contaminants (leaves, hair, dirt, etc.) are not allowed to enter the clean
water tank during the filling process. If using a suitable container, ensure it is always clean and free from debris.
Fill Level Indicator
A
Showing the clean-water tank empty
Water Flow Adjustment
1
Located on the left of the machine is the On / Off water tap (Fig.1).
Set the tap to enable the cleaning solution
The TTB1840NX/TTB1840NX-R is equipped with a large 18 litre clean-water
tank allowing large areas to be cleaned in a single fill.
2
(Fig.A)
.(Fig.2).
Machine Set-up Guide
B
Showing the clean-water tank full
2
27
27
3
Fill Indicator
(Fig.B)