Corghi A 9824 TI Manuel D'utilisation page 40

- Make sure that the wheel is secured to the table
top with inside clamping (Fig. 31a).
- Bring the horizontal arm in its work position
(Fig. 31b).
- Lower the vertical rod until it touches the rim
(Fig. 31c).
- Lock the vertical rod in this position.
- Remove valve core and connect the Doyfe
connector on the air hose to the valve stem
(Fig. 31d).
- Hold the tyre with your hands
and lift it until there is a slight
gap between the lower bead and
bottom edge of the rim in order
to close the upper bead and the
top of the rim (fig. 31d).
- Fully press the inflation pedal
down for a short period to the bead
seating position (fig. 31f). The tyre
will expand and the beads will
seat.
- Release the wheel from the sliding clamps on the
table top (Fig. 31e).
- Inflate the tyre by operating the proper pedal (Fig.
31d) in inflation position (average) (Fig. 31g) at short
intervals; check the pressure gauge frequently to
make sure that the pressure NEVER exceeds the
maximum pressure specified by the tyre manufac-
turer.
40
31a
31b
YES
31c
31d
NO
31e
31f
31g
A 9824 TI User Manual