Corghi A 9824 TI Manuel D'utilisation page 22

- Remove the plug and fit the rubber hose "M"
on connection "O" and tighten the hose clip
"N" (Fig.4).
- Open the bead-breaker arm "Q" (Fig.5).
- Fit the distance bush "P" over the bead break-
er cylinder rod and close the bead-breaker
arm inserting the cylinder rod through the
swiveling block.
- Hoist the machine off the pallet and proceed
with installation.
NOTE: nut "R" (Fig.5) must be screwed onto the
bead-breaker cylinder rod (as shown in Fig.5)
only after the machine has been installed and
hooked up to the compressed air line.
4. HOISTING/HANDLING
In order to remove the machine from the pallet, hook
it as shown in fig.6.
This hoisting point must be used whenever you need
to change the installation position of the machine. Do
not attempt to move the machine until it has been
disconnected from the electricity and compressed air
supply systems.
22
P
A 9824 TI User Manual
N
M
4
Q
R
1/8"
5
6