Corghi A 9824 TI Manuel D'utilisation page 38

mount or inflate any tyre and rim that are mismatched. For example, never mount a 16"
tyre on a 16.5" rim (or vice versa). This is very dangerous. A mismatched tyre and rim
could explode, resulting in an accident.
3. Never exceed the bead setting pressure (gauge on hose) provided by the tyre manu-
facturer, as stated on the sidewall of the tyre.
4. Never place your head or any part of your body over a tyre during the inflation process
or when attempting to seat beads.
This machine is not intended to be a restraining device for exploding tyres, tubes or rims.
5. Always stand back from the tyre changer when inflating, never lean over.
During this operation, noise levels assessed at 85 dB(A) may occur.
Wear hearing protection devices.
EXPLOSION HAZARD. An exploding tyre and rim may be propelled upward and
outward with enough force to cause serious injury or death.
Do not mount any tyre unless the tyre size (molded into the sidewall) matches the rim
size (stamped into the rim) exactly or if the rim or tyre are defective or damaged.
This tyre changer is not a safety device and will not restrain exploding tyres and rims.
Keep the area clear of bystanders.
9.8.b. INFLATING TYRES
- Release the wheel from the sliding
clamps on the table top (Fig. 28).
- Bring the horizontal arm in its work
position (Fig. 29a).
- Lower the verti-
cal rod until it
touches the rim
(Fig. 29b).
- Lock the vertical
rod in this posi-
tion.
38
WARNING
DANGER
YES
29a
NO
28
29b
A 9824 TI User Manual