Corghi A 9824 TI Manuel D'utilisation page 31

9.4. CLAMPING THE WHEEL
- Move manually the mounting head arm at
side, in not-working position (Fig. 17a).
- Place the wheel on the sliding clamp table
with the narrow side of the wheel's drop cen-
tre facing upward (tires must be removed
and re-fitted only from the narrow side).
- depress pedal
clamps to the outside of the table (Fig.18)
if you wish to clamp the rim on the outside
as shown in Figure 18 (recommended for
alloy rims).
- alternatively, keep pedal
pressed to bring the sliding clamps to the
centre of the table (Fig.19) if you wish to
clamp the rim on the inside (Fig.19).
A 9824 TI User Manual
17
17A
to bring the sliding
de-
18
19
31