Corghi A 9824 TI Manuel D'utilisation page 16

FOR CANADIAN MARKET ONLY:
•
The machine must be hard wired and fit a differential, 20A maximum, safety circuit-
breaker with 30 mA residual corrent.
•
Fit a fuse to protect the power supply line, rated as indicated on the general wiring
diagram in this manual.
An effective grounding connection is essential for correct operation of the machine.
Make sure the available pressure and the rendered capacity of the compressed air system
are compatible with those required for correct machine operation - see the "Technical Data"
section. For correct machine operation, the compressed air supply line must provide a
pressure range from no less than 8.5 bar to no more than 16 bar and guarantee an air flow
rate greater than the average consumption of the machine, which is equal to 187 Nl/min.
For correct equipment operation, the air produced must be suitably treated (not
above 5/4/4 according to ISO 8573-1)
Check that the Lubricator unit B fig. 2a contains air
lubricating oil; top up if necessary. Use SAE20 oil.
The customer must provide an air cut-off valve upstre-
am of the air treatment and regulator device supplied
with the machine.
1.2.d TECHNICAL DATA
- Turntable clamping capacity
- internal clamping .................................................................................................... from 13"
- external clamping ........................................................................................ from 10" to 24"
- Rim width ........................................................................................................ from 3.5" to 13"
- Maximum tyre diameter ..................................................................................................... 47"
- Maximum tyre width ........................................................................................................... 14"
- Power supply voltage: ................................................................................................. see table
- Bead breaker aperture:
- normal position .............................................................................................. from 2" to 12"
- racing position ............................................................................................... from 5" to 15"
- Bead breaking force ............................................................................. 15000 N (pressure 145 psi)
- Operating pressure .......................................................................................................145 psi
- Weight ............................................................................................................................. 238 Kg
- Noise levels in operating conditions ..................................................................< 70 dB (A)
16
NOTICE
NOTICE
B
2a
A 9824 TI User Manual