Corghi A 9824 TI Manuel D'utilisation page 23

4.1 INSTALLATION CLEARANCES
The machine must be installed in accordance with all applicable safety regula-
tions, including but not limited to those issued by OSHA.
RISK OF EXPLOSION OR FIRE. Never use the machine in an area where it will be
exposed to flammable vapours (gasoline, paint thinners solvents, etc.). Never install
the machine in a recessed area or below floor level.
IMPORTANT: for the correct and safe operation of the machine, the lighting level in
the place of use should be at least 300 lux.
Do not install the machine outdoors. It is designed for use in an indoor, sheltered area.
Install the tyre changer in the chosen work
position, complying with the minimum
clearances shown in Fig.7.
The surface must have a load-carrying
capacity of at least 1000 kg/m
Work environment conditions
- Relative humidity 30% - 95% without
condensation.
- Temperature 0°C - 50°C.
Each time the machine remains disconnected from the pneumatic line for long periods,
check the direct operation of the controls with the relative arm, following the pressure
restoration procedure. Carry out the first control operation very slowly.
A 9824 TI User Manual
WARNING
DANGER
NOTICE
2
.
WARNING
7
23