Corghi A 9824 TI Manuel D'utilisation page 30

9.3. BEAD BREAKING
- Fully deflate the tyre, removing the valve (Fig. 14).
- Position the wheel as shown in fig.16 and move
the bead breaking shoe near the rim edge.
IMPORTANT: During the bead breaking
operation, you are advised to keep the
turntable closed (clamp gripper towards the
centre).
- Press the pedal
the bead breaker and detach the bead.
- Repeat this operation on the other side of
the wheel.
- After detaching the beads, remove the old
balancing weights.
- Thoroughly lubricate the sides of the tyre
around the entire circumference of the lower
and upper bead (fig.17).
30
A
15
(fig.16) to operate
- In addition to operating the lever A, fig.15
to move the rim support into the correct
position for the width of the rim on which
you are working, the position of the show
must be adjusted appropriately for the size
of the tyre, using the pins B, fig.15a.
EXTENDABLE ARM
A Standard position
B Large wheels
position
15a
A 9824 TI User Manual
14
B
B
A
16