Publicité
Picture
Symptom
Cause and/or corrective actions
While editing using the DV connecting
cable, recording picture cannot be
monitored.
* Remove the DV connecting cable, and connect it
again.
Others
Symptom
Cause and/or corrective actions
The camcorder becomes warm.
* if the power of the cammcorder is on for a long time,
it becomes warm, which is not mulfunction.
The supplied Remote Commander docs
'not work.
> Set it to VIR4 or ID. (p. 12)
Something is blocking the infrared rays.
> Remove the obstacle.
'The batteries are dead.
> Insert new ones. (p. 12)
COMMANDER
is set to OFF in the menu system.
The battery is not inserted with the correct polarity.
> Insert the battery with the correct polarity. (p. 12)
'The CHARGE lamp flashes after you
charge the battery pack installed in the
camcorder.
"The camcorder is not malfunctioning.
No funetion works though the power is.
an.
{p- 8)
Disconnect the connection plug on the battery pack or
on the AC power adaptor, then reconnect it in about 1
minute. Turn the power on. If the functions still do
not work, press the RESET button on the back of the
cassette compatment lid using a sharp-pointed object.
(If you press the RESRT button, all the settings
including the date and time return to the default.)
ey
ERE
eee
Symptom
Corrective actions
'The VIR/CAMERA ot CHARGE lamp
does not light.
© Disconnect
the mains lead. After about ? minute,
reconnect the mains lead. (p. 17)
The CHARGE lamp flashes.
* Sec the chart on the next page.
(To be continued)
Jeuorppy
i
saujequaWug|
suopewsoju
; uoneW04
87
Publicité
