Télécharger Imprimer la page

Sony DVCAM DSR-PD1P Mode D'emploi page 85

Publicité

=
ee
#
iene
Power
Symptom
Cause and/or corrective actions
The power is not on.
* The battery pack is not installed.
> Install the battery pack. (p. 20)
The battery is dead.
> Use a charged battery pack. {p. 17)
The AC power adaptor is not connected to mains.
> Connect the AC power adaptor to mains. (p. 36)
If the poweris still not on after you tried the corrective actions
above, press the RESET button on the back of the cassette
compartment Jid using a sharp-pointed object. (Ifyou press
the RESET button, all the settings including the date and time
return to the default.) (p. 8)
While being operated in CAMCORDER mode, the camcorder
has been in Standby mode for more than 5 minutes.
Set the POWER switch to OTH, then to CAMCORDER. (p.
23)
The battery is dead
> Use a charged battery pack (p. 17)
The battery pack is quickly discharged.
* 'The ambient temperature is too low. (p..74)
The battery pack has not been charged fully.
> Charge the battery pack again. (p. 17)
The battery pack is completely dead, and cannot be recharged.
> Use another battery pack. (p. 36)
.
'The power goes off.
.
Symptom
Cause and/or corrective actions
START/STOP does not operate.
* The tape is stuck to the drum.
> Eject the tape. (p. 21)
* The tape has run out.
> Rewind the tape or use a new one. (p. 32)
'The POWER switch is set to VIR
> Set it to CAMCORDER. (p. 22)
* The tab on the cassette is out (red).
> Use a new tape or slide the tab. (p. 21)
The cassette camotbe removed fom
'The battery is dead.
the holder.
> Use a charged battery pack or the AC power adaptor.
(p. 17, 36)
Wand 2 indicators flash and no function + Moisture condensation has occurred.
except for cassette ejection works.
> Remove the cassette and leave the camcorder for at least 1
hour. (p.79)
"CLOCK SET" appears when the
= Reset the date and time. (p. 66)
camcorder is tumed on.
(To be continued)
sasieyuawi
suoneuros
/ UOBeUOJU
;eUONIPPY
a
85

Publicité

loading