Keysight Technologies RP7931A Guide D'utilisation Et D'entretien page 28

1 Quick Reference
:FUNCtion
:CURRent 0|OFF|1|ON
:MINMax 0|OFF|1|ON
:VOLTage 0|OFF|1|ON
:MINMax 0|OFF|1|ON
:PERiod <value>
:FUNCtion
:CURRent 0|OFF|1|ON
:VOLTage 0|OFF|1|ON
:SWEep
:NPLCycles <value>
:OFFSet
:POINts <value>
:POINts <value>
:TINTerval <value>
:WHOur
:RESet
:WINDow
[:TYPE] HANNing|RECTangular
[SOURce:]
ARB
:COUNt <value>|INFinity
:CURRent
:CDWell
[:LEVel] <value>{,<value>}|<Block>
:DWELl <value>
:POINts?
:FUNCtion
:TYPE CURRent|VOLTage
:TERMinate
:LAST 0|OFF|1|ON
[SOURce:]
CURRent
[:LEVel]
[:IMMediate]
[:AMPLitude] <value>
:TRIGgered
[:AMPLitude] <value>
:BWIDth
:RANGe 0 | 1
:LEVel 0 | 1, <value>
:LIMit
28
Enables/disables external current logging.
Enables/disables external min/max current logging.
Enables/disables external voltage logging.
Enables/disables external min/max voltage logging.
Sets the external datalog integration time.
Enables/disables current measurements.
Enables/disables voltage measurements.
Sets the measurement time in number of power line cycles.
Defines the offset in a data sweep for triggered measurements.
Defines the number of points in a measurement.
Defines the time period between measurement samples.
Resets the accumulated watt-hour measurement.
Selects the measurement window.
Specifies the number of times the Arb repeats.
Specifies the level of each point in the Arb.
Specifies the dwell time of each point in the Arb.
Returns the number of points in the Arb.
Specifies either a voltage or current Arb.
Selects the output setting after the Arb ends.
Sets the output current when in current priority mode
Sets the triggered output current
Sets the current compensation. (RP793xA,RP794xA)
Sets the compensation frequency. (RP793xA, RP794xA)
Keysight RP7900 Series Operating and Service Guide