Publicité
Les langues disponibles
Les langues disponibles
5 SCPI Programming Reference
Compatibility Commands
This section describes the compatibility of the Keysight RPS7900-series with existing Keysight N7900-
series Advanced Power Systems (APS). Because of their feature sets, only programs written for the
N7900 Advanced Power Systems are compatible with the Regenerative Power System (RPS) models.
Note that not all features are common to both families.
APS code-compatible commands with RPS models
These Keysight N7900 APS commands are compatible with the RPS models.
N7900-series APS commands
[SOURce]
:RESistance <value>
:STATe <Bool>
APS feature set comparison with RPS models
The following table compares the feature set of the Keysight N7900 APS models with the feature set of
the RPS models
Feature
Two quadrant operation
Voltage and current priority operation
Voltage and current slew rates
Resistance programming (in voltage priority mode)
Output bandwidth selection (in voltage priority mode)
Output triggering
Single step output change
Output list of up to 512 points
Constant-dwell arbitrary waveform – up to 64k points
Scalar measurements
DC, RMS, High/Low, Min/Max current scalar measurements
DC, RMS, High/Low, Min/Max voltage scalar measurements
Average Power
Amp hours and Watt hours
Digitized measurements
Simultaneous voltage and current measurements
Current, voltage, and power array data
External data logging
272
Action or equivalence on RPS models
[SOURce]
:VOLTage
:RESistance <value>
:STATe <Bool>
In N7900 APS models?
Keysight RP7900 Series Operating and Service Guide
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Publicité
