Publicité
Les langues disponibles
Les langues disponibles
Appendix A Keysight SD1000A Safety Disconnect System
Installing the Keysight SD1000A Safety Disconnect System
Keysight SD1000A-to-RP7900 Connections
External Control Connections
For items supplied, refer to
Single Unit
Connections.
Keysight SD1000A-to-RP7900 Connections
As shown in the following figures, Install the SDS unit as close as possible to the RP7900 series unit.
Both units are designed to fit into a standard System II racks. Rack ears are built into the SDS unit.
If you are using a primary/secondary power supply configuration, the primary power supply must be
connected to the SDS unit.
Simplified SDS Block Diagram
Wire Connections
The following factors should be considered when wiring the RPS, SDS, and DUT:
Load wire current carrying capacity
l
Load wire insulation rating must be equivalent to the maximum output voltage
l
Load wire voltage drop, noise, and impedance effect
l
Tightening torque of the output bolts cannot exceed 10.8 Nm (8 lb-ft).
Sense connections on the SDS unit must NOT be used when local sensing.
316
Items
Supplied. For detailed connection information and wire sizes, refer to
Keysight RP7900 Series Operating and Service Guide
Publicité
