Publicité
Les langues disponibles
Les langues disponibles
Specifications and Characteristics - RP795xA, RP796xA
Specifications - RP795xA, RP796xA
Supplemental Characteristics - RP795xA, RP796xA
Common Characteristics
AC Input Efficiency, Power Factor, and THD
Output Impedance Graphs
Inductive Load Boundary for Constant Current (CC) Operation
Capacitive Load Boundary for Constant Voltage (CV) Operation
Voltage Programming Response
Excessive Dynamic Protection
Output Quadrants
Specifications - RP795xA, RP796xA
Unless otherwise noted, specifications are warranted over the ambient temperature range of 0 to 40°C
after a 30-minute warm-up period. Specifications apply at the output terminals, with the sense
terminals connected to the output terminals (local sensing).
Specification
DC Ratings
Voltage source:
Current source and sink:
Power:
Output ripple & noise
CV peak-to-peak: 1
CV rms: 2
Load regulation
Voltage:
Current:
Voltage programming accuracy: 3
Voltage measurement accuracy: 3
Current programming &
measurement accuracy: 3
Transient response 4
Recovery Time:
Settling band:
1 From 20 Hz to 20 MHz (-3dB bandwidth) with resistive load, terminals ungrounded, or either terminal grounded
2 From 20 Hz to 10 MHz (-3dB bandwidth) with resistive load, terminals ungrounded, or either terminal grounded
3 Percent of value + offset; at 25°C ±5°C after a 30 minute warm-up; measurement NPLC=1; valid for 1 year, see
with a load lead voltage drop of up to 1V per lead - see
4 Time to recover to within the settling band following a step change from 50% to 100% of full load at the maximum slew rate
Keysight RP7900 Series Operating and Service Guide
RP7951A, RP7961A
RP7952A, RP7962A
0 to 500 V
0 to ±20 A
0 to ±5 kW
500 mV
100 mV
30 mV
9 mA
0.03% + 60 mV
0.03% + 80 mV
0.1% + 12 mA
500 µs
1.25 V
Wire Size
for additional information about load lead voltage drop
1 Quick Reference
RP7953A, RP7963A
0 to 500 V
0 to ±40 A
0 to ±10 kW
0 to ±10 kW
500 mV
100 mV
30 mV
17 mA
0.03% + 60 mV
0.03% + 120 mV
0.03% + 80 mV
0.03% + 160 mV
0.1% + 24 mA
0.1% + 12 mA
500 µs
1.25 V
Calibration Interval
0 to 950 V
0 to ±20 A
1000 mV
200 mV
60 mV
9 mA
500 µs
2.375 V
53
Publicité
