Wilo Stratos GIGA Notice De Montage Et De Mise En Service page 93

2.4 Transport
2.5 Installing/dismantling
Installation and operating instructions • Wilo-Stratos GIGA, Wilo-Stratos GIGA-D, Wilo-Stratos GIGA B • Ed.01/2024-02
NOTICE
The magnets inside the motor do not pose a danger provided the motor
is completely assembled. Persons with pacemakers can approach the
pump without restrictions.
• Wear protective equipment:
Safety gloves for protection against cuts
–
Safety shoes
–
Sealed safety glasses
–
Safety helmet (when using lifting equipment)
–
• Only use legally specified and approved lifting slings.
• Select the lifting sling based on the prevailing conditions
(weather, slinging point, load etc.).
• Always attach the lifting sling to the designated slinging points
(lifting eyes).
• Position the lifting accessory in a way that ensures stability
during use.
• When using lifting equipment, a second person must be
present to coordinate the procedure if required (e.g. if the op-
erator's field of vision is blocked).
• Persons must not stand underneath suspended loads. Do not
move loads over workplaces where people are present.
Please note the following information during transport and
prior to installation:
• Do not reach into suction ports, discharge ports or other open-
ings.
• Avoid the penetration of foreign objects. To this end, leave the
protective covers or packaging on until they have to be re-
moved for installation.
• Packaging and covers may be removed from suction or outlet
openings for inspection purposes. They must be put back on
afterwards to protect the pump and ensure safety.
• Wear protective equipment:
Safety shoes
–
Safety gloves for protection against cuts
–
Safety helmet (when using lifting equipment)
–
• Locally applicable laws and regulations on work safety and ac-
cident prevention must be complied with.
• The procedure described in the installation and operating in-
structions for shutting down the product/unit must be strictly
observed.
• Disconnect the device from the mains and secure it against be-
ing switched on again without authorisation.
• All rotating parts must be at a standstill.
en
93