Wilo Stratos GIGA Notice De Montage Et De Mise En Service page 133

11.5.2 Display menu mode
"One level down" menu element
"Information" menu element
"One level up" menu element
"Selection/setting" menu element
±
11.5.3 Display error page
E000
Fig. 38: Error page (error status)
11.5.4 Menu groups
Basic menu
Installation and operating instructions • Wilo-Stratos GIGA, Wilo-Stratos GIGA-D, Wilo-Stratos GIGA B • Ed.01/2024-02
The electronic module functions can be called via the menu structure. The menu contains
sub-menus on several levels. Each menu and submenu is assigned a number.
Use the menu items "Level up" or "Level down" to toggle between menu levels, e.g. from
menu <4.1.0.0> to <4.1.1.0>.
The currently selected menu item is identified by the menu number and the associated
symbol on the display.
Within a menu level, you can select menu numbers in sequence by turning the operating
button.
Every menu level can contain four different element types:
When the display shows the "Level down" arrow, pressing the operating button toggles to
the next lower menu level. The number of the new menu level counts up one digit after tog-
gling (e.g. from menu <4.1.0.0> to menu <4.1.1.0>).
When this symbol appears, current settings or measurements cannot be changed (default
symbol "access disable"). The displayed information is read-only.
When the display shows the "Level up" arrow, briefly pressing the operating button toggles
to the next higher menu level (e.g. from menu <4.1.5.0> to menu <4.1.0.0>).
The adjacent "Selection/Setting" symbol does not appear on the display. In these instruc-
tions, this symbol marks menu items that allow a selection or setting to be made.
If a "Selection/Setting" menu item is selected, pressing the operating button switches to
editing mode.
In editing mode, the adjustable value flashes. Turn the operating button to adjust the value;
press the operating button again to save the set value.
In some menus, the display briefly shows the "OK" symbol after you press the operating but-
ton to confirm the entry
If an error occurs, the display changes from the status page to the error page. The display
shows the letter "E" and the three-digit error code, separated by a decimal point.
E.025
• <1.0.0.0>: Setpoint settings
• <2.0.0.0>: Operating mode setting
• <3.0.0.0>: "Pump on/off" setting
The menus show settings that may need to be changed during normal operation of the
pump.
NOTICE
If the operating button is not operated for 30 s in menu mode, the dis-
play returns to the status page. Any changes will not be saved.
NOTICE
Press and hold the operating button for 2 s while the "Level up" arrow is
shown on the display to return to the status display.
en
133