Wilo Stratos GIGA Notice De Montage Et De Mise En Service page 141

No. Name
5.2.0.0 BMS
5.2.1.0 LON / CAN / IF
module Wink/
Service
5.2.2.0 Local/remote
operation
5.2.3.0 Bus address
5.2.4.0 IF gateway val A
5.2.5.0 IF gateway val C
5.2.6.0 IF gateway val E
5.2.7.0 IF gateway val F
5.3.0.0 In1 (sensor in-
put)
5.3.1.0 In1 (sensor value
range)
5.3.2.0 In1 (value range)
5.4.0.0 In2
5.4.1.0 In2 active/inac-
tive
5.4.2.0 In2 (value range)
5.5.0.0 PID parameter
5.5.1.0 P parameter
5.5.2.0 I parameter
5.5.3.0 D parameter
5.6.0.0 Error
5.6.1.0 HV/AC
5.6.2.0 Emergency oper-
ation speed
5.6.3.0 Auto reset time
Installation and operating instructions • Wilo-Stratos GIGA, Wilo-Stratos GIGA-D, Wilo-Stratos GIGA B • Ed.01/2024-02
Type Symbol Values/explanations
Settings for Building Management System
(BMS) – building automation
The wink function permits the identification
±
of a device in the BMS network. A "wink" is
executed by confirmation.
BMS local operation
±
Remote BMS operation
Setting of bus address
±
Specific settings of the IF module, depends
±
on protocol type
±
±
±
Settings for sensor input 1
Display of sensor value range 1
Value range setting Possible values:
±
0 ... 10 V / 2 ... 10 V / 0 ... 20 mA / 4 ... 20 mA
ON
±
External setpoint input 2 active
OFF
External setpoint input 2 inactive
Value range setting Possible values:
±
0 ... 10 V / 2 ... 10 V / 0 ... 20 mA / 4 ... 20 mA
Settings for PID-Control
Setting of the proportional term of the con-
±
trol
Setting of the integral term of the control
±
Setting of the derivative term of the control
±
Settings for behaviour in the event of a
fault
HV "heating" mode
±
AC "cooling/air-conditioning" mode
Display of emergency operation speed
Time until automatic acknowledgement of
±
an error
Display conditions
Only displayed if BMS is active, incl.
all submenus
Only displayed when LON, CAN or IF
module is active
Temporary state, automatic reset to
remote operation after 5 min
Further information can be found in
the installation and operating in-
structions of the IF modules
Not displayed in constant speed
mode (incl. all sub-menus)
Not displayed with PID-Control
External setpoint input 2 settings
Not displayed when In2 = inactive
Only displayed if PID-Control is act-
ive (incl. all submenus)
en
141