Publicité
Except for the front access covers, do not remove or penetrate any cover, nor any cover of other
accessory hardware supplied by Miltenyi Biotec. Only authorized personnel is allowed to remove any
other cover of the instrument. Never push an foreign object through an opening into the instrument.
Do not use the instrument if
it has been opened or disassembled
l
it has been dropped or damaged
l
it has damaged or broken parts
l
it has a damaged power cable
l
an object has been entered through the ventilation slots
l
an object has been dropped into the instrument
l
The instrument is intended for indoor use only. If liquids enter the instrument, it may lead to electric shorts,
shock, or fire. Take special care while handling liquids.
Do not allow liquids to enter the interior of the instrument. Protect the instrument against accidental
spillages and splashes. Clean up spillages immediately. Do not operate the instrument if liquids have
entered the instrument. Do not use the instrument in a wet and damp location. Avoid areas with high
humidity or condensation. Moving the instrument from a cold environment – such as a cold room at 5 °C – to
room temperature may cause condensation inside the instrument. In such cases, wait for the instrument to
dehumidify before operating it. Before cleaning, unplug the instrument. Do not use liquid or cleaning spray,
always use a damp cloth.
Protect the instrument from overheating. Do not use the instrument in areas with more than 25 °C. Ensure
adequate air circulation in the room when the instrument is operated. Allow sufficient air circulation around
the instrument – at least 15 cm on all sides – during operation. Do not place the instrument near radiators,
heat registers, stoves, or other equipment (including amplifiers) that generate heat. Protect the
instrument from direct sunlight. Do not cover the slots and openings of the instrument as these are
provided for ventilation. Do not place the instrument in a built-in rack or similar confined spaces unless the
space has been specifically designed to provide proper ventilation.
The instrument is equipped with a three-wire electrical grounding-type plug that has a third pin for grounding.
This plug fits in a grounded power outlet only. This is a safety feature.
Do not try to insert the plug into a non-grounded power outlet. If you cannot insert the plug into the
outlet, contact your local electrician to replace the outlet.
Only peripheral devices that comply to UL 60950 are allowed to be connected to the RS232 connector labeled
COM1.
Only the 2D code reader that was delivered with the instrument should be connected to to the RS232/BCR
port. External laser devices connected to to the RS232/BCR port have to comply with the standard IEC 60825-1.
In order to ensure electromagnetic compliance, connect peripheral devices only with double-shielded cables
and only use the power cable and the keypad included in delivery. Use the keypad with MACSQuant X models
only.
10
Publicité
