Truma Mover XT4 Mode D'emploi page 41

Mover XT4
1 2
Fig. 33
Switch off the remote control with the slide switch
on the side. (see Kapitel 4.5.1)
After switching on the control unit (e.g. with the bat-
tery cut-off switch), wait (approx. 15 seconds) until
the red LED (Fig. 33-2) starts flashing slowly.
Press and hold the reset button (Fig. 33-1) on the
control unit. Wait until the LED (Fig. 33-2) flashes
very quickly.
Press and hold the left ENGAGE button
remote control.
Switch on the remote control with the slide switch
on the side while doing so.
Release the left ENGAGE button
Once the appliances are paired, the red LED (Fig. 33-2)
on the control unit and the
control light up continously.
If pairing was unsuccessful, the red LED (Fig. 33-2)
flashes and you have to repeat the process.
60020-00216 00 08/2022
on the
.
symbol on the remote
7 Care and maintenance

RISK
Severe to lethal injury due to short
circuiting
Parts of the appliance are supplied with power
over an on-board power supply consisting of
12 V batteries. In the event of high electrical
loads or a short circuit, very high currents can
flow through the supply lines, causing the
cables to heat up and a cable fire to break out.
Fuse cables with appropriate safety fuses.
Cover the battery terminals.
Cover open electrical contacts.
Use isolated plug-in connectors.
NOTICE
Damage to the manoeuvring system due to
incorrect cleaning
Do not clean the manoeuvring system with a
high-pressure cleaner.
Only use gentle detergents.
Cleaning and user-performed maintenance must not be
carried out by children when unsupervised.
7.1 12 V battery care
Notes for handling batteries
When handling batteries, pay attention to the
manufacturer's safety instructions and data sheets.
Ensure that the terminal clamps are secure.
Secure battery poles with protection caps in order to
prevent a short circuit
When removing the battery, first disconnect the
earth connection (negative terminal), followed by the
positive terminal.
When installing the battery, first connect the positive
terminal followed by the negative terminal.
Battery care (including maintenance-free batteries)
In order to achieve a long battery service life, attention
must be paid to the following points:
Batteries should be fully charged before and after
removing power.
For stationary periods of longer than 24 hours, inter-
rupt the power circuit (e.g. using the battery cut-off
switch or by disconnecting the battery poles).
For longer stationary periods the battery must be
disconnected and charged for 24 hours at least eve-
ry 12 weeks.
 In winter, store the fully-charged battery in a cool
and frost-free place and recharge at regular intervals
(every 12 weeks).
7.2 Remote control care
The remote control must be kept in a dry place.
Remove the remote control's batteries during exten-
ded stationary periods (e.g. in winter) to prevent the
batteries from going flat.
Care and maintenance
EN 41