Truma Mover XT4 Mode D'emploi page 27

Mover XT4
When jacking up the caravan, the manoeuvring system
must not be used as a support point, as this could da-
mage the drive unit and the vehicle.
The empty weight of the vehicle increases by the
weight of the manoeuvring system, which reduces the
payload of the vehicle.
Do not exceed the permissible gross weight when
loading the caravan.
Depending on the weight of the caravan, the manoeuv-
ring system can only overcome obstacles (e.g. kerbs)
from a height of approx. 5 cm using auxiliary equip-
ment (e.g. wedges).
Levelling ramps must not exceed an incline of 25 % (14
°). Otherwise, depending on the weight of the vehicle, it
may not be possible to overcome the incline or the tyre
tread may be damaged.
Levellers or tyre protection systems to prevent flat-
spotting often have a steeper incline and are not sui-
table for use with a manoeuvring system.
Sensitive objects such as cameras, DVD players etc.
must not be kept in the stowage box near the control
unit or the motor cables, as the powerful electromagne-
tic fields may damage them.
2.4 What to do if malfunctions occur
Emergency stop
The side slide switch on the remote control (ON / OFF)
also acts as an "Emergency Stop switch".
Switch the side slide switch to "OFF" immediately in
case of any noticeable problems, e. g. uncontrolled be-
haviour of the manoeuvring system.
60020-00216 00 08/2022
3 Intended use
3.1 Proper use
The Mover XT4 is a manoeuvring system which allows
a caravan to be manoeuvred without the aid of the to-
wing vehicle.
The Mover XT4 was designed for use on dual-axle cara-
vans with a gross weight of up to 3100 kg.
The caravan may only be manoeuvred with the mano-
euvring system on campsites and private property.
3.2 Use that is not compliant with the
intended purpose
The caravan must not be manoeuvred with the mano-
euvring system on public roads.
The manoeuvring system may only be used for ca-
ravans. Manoeuvring of other trailers, such as boat
trailers, horsebox trailers, market trailers, construction
trailers or similar items, is prohibited.
3.3 Installation, removal, conversion
Only competent and trained people (experts)
are permitted to install and repair the Truma
product and to carry out the function test, at
the same time observing the installation and
operating instructions and the currently re-
cognised technical regulations. Experts are people who,
based on their specialist instruction and training, their
knowledge and experience with Truma products and
the relevant standards, can carry out the necessary
work properly and identify potential hazards.
People who are not experts should observe the
following:
Do not mount the appliance, do not install it in other
locations and do not install it in other vehicles.
Do not dismantle, convert or repair the appliance
yourself.
Installation, removal or conversion work may only be
carried out by experts.
Intended use
EN 27