Truma Mover XT4 Mode D'emploi page 29

Mover XT4
4.2 Product label
The appliance type and serial number are printed on the
type plate.
Type plate
To ensure that the general operating permit (ABE) is va-
lid, the type plates must be present on the left and right
of each of the mounting tubes.
Fig. 4
The type plate of the remote control can be found in the
remote control's battery compartment.
The type plate of the control unit is located on the un-
derside of the control unit.
4.3 Function
Coping with inclines (max. climbing ability)
The Mover XT4 has been designed to cope with inc-
lines of up to approx. 10 % bearing a gross weight of
3100 kg on a suitable surface.
 13 % = 13 metre difference in altitude over a dis-
tance of 100 metres
Once the drive rollers have been engaged against the
tyres using the remote control, the manoeuvring system
is ready for operation.
Manoeuvring is carried out exclusively via the remote
control, which transmits radio signals to the control
unit. A separately installed 12 V lead-acid battery or sui-
table lead-gel battery (not supplied) provides the control
unit with electrical power.
4.4 Power supply
Always observe the operating instructions and the
"Safety instructions" prior to starting. The vehic-
le user is responsible for correct operation of the
device.
4.4.1 Power supply
For optimum operation, we recommend the Truma Po-
werSet BC and high-performance Optima® batteries.
60020-00216 00 08/2022
2
1
Body-mounted batteries (caravans with self-sufficient
power supply with correspondingly large capacity; see
table below) are also suitable.
Batteries
NOTICE
Malfunctions during operation due to incor-
rect power source
To guarantee proper operation of the mano-
euvring system, it may only be operated with a
charged battery (≥ 12 V).
Operation with a charger as power source is
not possible and prohibited.
Recommended battery capacities
The 12 V battery used must be certified in accordance
with the national standards and regulations of the coun-
try of use and in accordance with the manufacturer's in-
stallation instructions. The battery must be dimensioned
in accordance with the technical requirements of the
manoeuvring system.
Starter batteries are not suitable.
Batteries with greater capacity allow the manoeuvring
system to be used for longer.
Round cell
technology
Mano- Capacity in Ah
euvring
system
XT4 55
Charger
For optimum battery charging, we recommend the Tru-
ma BC 10 charger (a component of the PowerSet BC),
which is suitable for all battery types up to 200 Ah.
Fig. 5
4.5 Remote control
4.5.1 The remote control's functions
NOTICE
Damage to the remote control due to mois-
ture or heat
If moisture gets into the remote control or it is
exposed to strong sunlight for too long, this can
damage the remote control.
Protect the remote control from moisture.
Protect the remote control from strong
sunlight.
If there are other devices that work on the same fre-
quency (e.g. wireless garage doors, video surveillance
cameras, baby monitors, etc.) nearby, the manoeuvring
Product description
Gel / Lead-acid battery
AGM (liquid electrolyte)
70 80
EN 29