Truma Mover XT4 Mode D'emploi page 40

Malfunctions
6 Malfunctions
6.1 Troubleshooting guide
Before contacting Customer Service:
Check whether the batteries in the remote control
•
are working perfectly.
Is the remote control paired with the control unit?
•
Pairing the electronic control unit with the radio remote
control see Kapitel 6.2.
Check that the caravan's 13-pole plug or adapter is
properly plugged into the safety socket.
Check that the caravan battery is in good condition
and is fully charged.
 Battery performance can deteriorate considerably at
cold ambient temperatures.
Check that the fuse in the battery connector cable is
in order. If the fuse is defective, check the system for
possible short circuits.
 If errors occur, the remote control always switches
off once the symbols have been shown.
Malfunction Cause and remedy
Manoeuvring •
system not
working
•
Control unit is overheated.
Manoeuvring
system not wor-
king and red LED
•
on control unit
flashing
40 EN
Check the power supply (the
green LED on the control
unit must be lit). Replace a
defective fuse in the battery
connection cable of the ma-
noeuvring system only with
an original Truma spare part
(part no. 60040-00169).
Interrupt the power supply
for at least 20 seconds. Res-
tore the power supply. The
green LED on the control unit
should be lit.
Interrupt the power supply
with the battery cut-off switch
and remove the key. Allow the
control unit to cool down for
at least 20 minutes. Then start
the manoeuvring system.
Malfunction Cause and remedy
Manoeuvring
system not re-
sponding to
Remote control's battery charge
commands from
is too low
remote control
or only with
•
interruptions
Manoeuvring system's battery
low – green LED on control unit
flashes.
•
Drive roller sli-
•
ding off tyre
•
•
Disengage the manoeuvring sys-
Manoeuvring
tem manually (see Kapitel 5.7)
system not
disengaging
If these actions do not remedy the problem, please
contact Truma Service.
6.2 Pairing the electronic control unit
with the radio remote control
The remote control and the control unit are paired in the
factory.
If the control unit or the remote control is replaced, they
must be paired again.
The drive rollers must not be engaged
Check that the battery is properly connected and in
good condition, and that the control unit is being
supplied with 12 V.
Make sure that the caravan plug is plugged into the
safety socket.
Read the following instructions beforehand, as
you only have limited time for pairing (approx. 10
seconds).
 You will need a pen, a small screwdriver or a similar
item to press the reset button (Fig. 33-1).
Mover XT4
Symbols flash on the remote
control
Check the manoeuvring
system's battery. Charge or
replace battery if necessary.
Check tyre pressure and ad-
just if necessary.
Check tread and replace tyres
if necessary.
Disengage the manoeuvring
system and measure the
gap between the tyres and
drive roller. The gap must be
20 mm.
60020-00216 00 08/2022