Truma Mover XT4 Mode D'emploi page 34

Operation
Fig. 11
Turn the key. This establishes the power supply to
the manoeuvring system.
5.2.2 Safety socket
For safety reasons, the manoeuvring system can only
be operated if the caravan's 13-pole plug or adapter is
plugged into the safety socket.
1
3
Fig. 12
If necessary, remove the 13-pole plug or adapter
from the vehicle.
Open and hold the safety socket cover (Fig. 12-1)
Plug the 13-pole plug or adapter into the caravan's
safety socket (Fig. 12-2). The lug on the adapter
must slide into the safety socket groove.
Turn the 13-pole plug or adapter one quarter of a
turn in an anti-clockwise direction (Fig. 12-3) and let
the cover engage on the adapter.
If the 13-pole plug or adapter is pulled out of the safety
socket during operation, the manoeuvring system is
switched off immediately.
5.2.3 Switch on the remote control
NOTICE
Property damage due to uncontrolled remo-
te control button commands
If you put the switched-on remote control into
your trouser pockets, or if it is used by children,
the manouvring system can be set in motion
unintentionally.
Always switch off the remote control once
manoeuvring is complete.
Do not put the remote control into your
trouser or similar pockets.
Keep the remote control out of the reach of
children.
34 EN
No other remote control function must be active (slide
control / control knob must be in the centre position)
when the remote control is switched on.
Fig. 13
5.3

2
The drive rollers are engaged on the caravan wheels by
means of the remote control.
Fig. 14
The drive commands with the control knob and slide
control are executed only when the drive rollers are
completely engaged. If the engagement is interrupted,
it must be restarted and performed in full. Drive com-
mands can only be executed afterwards.
Slide the slide switch on the side upwards (Fig. 13).
After switch-on, the
bar for approx. 5 seconds. Then the
lights up continuously and the manoeuvring system
is ready for operation.
Engage the manoeuvring system
CAUTION
Personal injury due to the caravan rolling
away
If the parking brake is released during the enga-
gement, the caravan can roll away in an uncont-
rolled manner.
Only release the caravan's parking brake
when the drive rollers on both sides are com-
pletely engaged.
To engage the drive units, press and hold both the
ENGAGE buttons
An acoustic signal sounds and engagement of the
drive rollers starts after a 3 second safety delay.
The ENGAGE buttons
The symbol flashes in the toolbar during the
engagement.
If the engagement is complete, two acoustic signals
sound and the symbol disappears from the
toolbar.
Mover XT4
symbol flashes in the tool-
symbol
at the same time (Fig. 14).
can be released.
60020-00216 00 08/2022