Hoisting/Handling; Installation Clearances; Work Environment Conditions; Installation - Corghi PW IW 6 Manuel D'utilisation

Masquer les pouces Voir aussi pour PW IW 6:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

In order to remove the machine from the pallet, lift it as shown in fig.2.
This hoisting point must be used whenever you need to change the installation position
of the machine. Do not attempt to move the machine until it has been disconnected from
the electricity and compressed air supply systems.

INSTaLLaTIoN CLEaraNCES

CAUTION
The place where the machine is to be installed must conform to applicable safety at
work regulations.
WARNING
The machine must not be installed in an open area.
Move the machine to the designated installation site, respecting the minimum distances
reported in fig.3.
- Relative humidity: 30÷95% without condensation
- Temperature 0°C - +55°C
CAUTION
The machine must not be operated in potentially explosive atmosphere.
ATTENTION
Install the unit at least 60 cm. from any heat source (fig.3).
Level the machine using the adjustable feet (7 fig.4).
Hook-up to the electric mains (see the section on "electricAl And pneumAtic hook-
up").
Additional modules may be installed on the base module to obtain various machine
compositions.
To build up machines with several modules, connect the additional modules to the base
module in a number not exceeding the maximum permitted, which is 48 heads.
26

HoISTING/HaNDLING

Work environment conditions

INSTaLLaTIoN

PW IW ~ 6" 8" 10" base module
PW IW ~ 6" 8" 10" additional module
User manual PW IW 6" 8" 10"

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Pw iw 8Pw iw 10

Table des Matières