Pando PHB-861 Manuel D'utilisation page 242

INOXPAN S.L. Pando
Risk of serious damage to health
The oven becomes very hot when in pyrolytic mode. Never clean baking trays
and pans in pyrolytic mode, the coating on the trays and pans will be removed and harmful
gases will be released. In general, pyrolytic mode should not be used to clean accessories.
Before starting the pyrolytic mode
Caution!
1. Before activating the pyrolytic mode, remove accessories and cooking utensils, including
removable rails, from the cooking compartment. This will not only achieve good cleaning
results, but will also ensure that the accessories have a long service life.
2. Before starting the cleaning function, remove food residues manually.
3. Clean the inside of the oven door edges of the oven cooking compartment and the area
around the gasket. Do not rub or remove the gasket.
4. While performing these operations, make sure that the oven is switched off.
Setting the pyrolytic self-cleaning mode
1. Switch on the oven by pressing the button
2. Select the "Pyrolytic" operating mode by pressing
3. Check that all accessories and food have been removed/removed and that the door is
securely closed.
4. Press the "Start / Stop" button
5. Ventilate the kitchen when the cleaning function is running.
6. The cooking compartment locks the door shortly after the start of operation. The cooking
compartment cannot be opened until the temperature is reduced to a relatively safe
section.
Pyrolysis mode end signal
An acoustic signal sounds continuously and the oven stops heating. This means that the
pyrolytic mode has ended. You can press the button
sounds will turn off automatically later.
!
.
.
to start the cleaning operation.
to turn off the sounds, or the
42
Pyrolysis programme
EN
PHP-864