Publicité
Les langues disponibles
Les langues disponibles
INOXPAN S.L. Pando
TO SOLVE POSSIBLE PROBLEMS
OF YOUR OVEN IF NECESSARY
Before calling the after-sales service, be sure to check that the problem you are
experiencing is not listed in the table below or that the problem is due to incorrect
operations. Often, you can solve the problem yourself at no extra cost.
If a dish does not turn out exactly the way you want it to, you will find plenty of tips and
instructions for preparation at the end of the instruction manual.
Possible
Incidents
cause
The
oven
Cutting of current
does
not
work.
The fan does not work all the time
in the mode: "Ventirer heating".
After a cooking process a noise is
heard and an air flow is observed in
the vicinity of the control panel.
The food has not been cooked
sufficiently in the time indicated in
the recipe.
Uneven browning in the cooked
food
The lamp does not light.
RISK
OF ELECTRICAL SHOCK!
Repairs carried out incorrectly are dangerous. Repairs and replacement of damaged power cables
must only be carried out by one of our qualified after-sales technicians. If the oven is defective,
disconnect it from the
after-sales service.
Solutions
Check if the kitchen light or other kitchen appliances are
working.
This is normal operation due to the best possible heat
distribution and furnace performance.
The cooling fan continues to run, to prevent high humidity
conditions in the cavity and cool the oven for your
comfort. The cooling fan will turn off automatically.
A temperature different from the recipe temperature has
been used. Check the temperatures again. The quantities
of ingredients are different from the recipe. Check the
recipe again.
The temperature setting is too high, or the shelf level
could be optimised. Recheck the recipe and settings. The
surface finish and/or the colour and/or the material of the
bakeware were not suitable for the selected oven
function. When using radiant heat, such as in "Top and
bottom heating" mode, use ovenware with matt finish,
dark colour and light weight.
If it is necessary to replace the lamp, this operation must
be carried out by the Pando Technical Assistance Service
or a qualified installer.
mains or switch off the circuit breaker in the fuse box. Please contact our
53
EN
PHB-861
PHTV-862
PHP-864
Publicité
