Ransomes HIGHWAY 213 VL Série Manuel D'utilisation page 55

Table des Matières

Fig.40

ADJUSTMENTS

Read the safety instructions

Fan Belt Tension (Fig.40)

The tension on the belt is correct when the belt can

be depressed 7 to 9mm (0.28 - 0.35in) under a load

of 10kgf (22lbs) midway between the crankshaft

pulley and the alternator pulley.

To adjust:

(a) Release the two bolts holding the (A Fig.40)

alternator and adjust alternator until the tension

is correct.

(b) Re-tighten the bolts securely after adjusting.

MOW FOOT PEDAL LEVER

The mow foot pedal lever releases the divertor valve

spools via cables and a latch mechanism.

Adjustment is correct when full pedal travel releases

all divertor valves without pulling the latch pin out of

the clevis on divertor valve 1 . The cable to the front

divertor valves 2 & 3 should almost be fully

retracted.

To adjust:

(a) Release the locknut on the cable adjuster at

the foot pedal.

(b) Turn the adjuster to obtain correct adjustment.

(c)

Retighten the locknut securely after adjusting.

REAR WHEEL SETTING

The rear wheels should be set parallel to each other.

The rear tyres should then be the same dimension

at the front and at the rear.

To adjust:

(a) Loosen the locknuts on the tie rods.

(b) Rotate tie rods until the wheels are correctly

set.

(c)

Re-tighten locknuts securely.

Table des Matières

Highway 213 vk série