Ransomes HIGHWAY 213 VL Série Manuel D'utilisation page 53

52
Fig.36
Fig.37
Fig.38
Fig.39
Every 400 working hours Every 400 working hours Every 400 working hours Every 400 working hours Every 400 working hours
Replace fuel filters
CARTRIDGE TYPE
(a) Remove filter cartridge (A Fig.36) and discard.
(b) Apply fuel oil thinly over gasket and tighten the
cartridge into position hand tight.
IN-LINE TYPE
(a) Release clamp bands either side of the in-
line filter (B Fig.36) and remove fuel pipes.
(b) Fit new in-line filter to fuel pipes and replace
clamp bands.
Every 500 working hours or after 6 times Every 500 working hours or after 6 times Every 500 working hours or after 6 times
Every 500 working hours or after 6 times Every 500 working hours or after 6 times
cleaning cleaning cleaning cleaning cleaning
Change air cleaner element
Proceed as quoted in "every 100 hours" but discard
the element and replace with a new one.
MACHINE MACHINE
MACHINE MACHINE MACHINE
Daily (Every 8 working hours) Daily (Every 8 working hours) Daily (Every 8 working hours) Daily (Every 8 working hours) Daily (Every 8 working hours)
Seat Compartment
Release seat catch (A Fig.37) Inspect and clean out
if necessary all grass clippings and dirt underneath
seat and between tanks (Fig.38).
Daily (Every 8 working hours) Daily (Every 8 working hours) Daily (Every 8 working hours)
Daily (Every 8 working hours) Daily (Every 8 working hours)
Check coolant level in radiator expansion bottle (A
Fig.39). Top up is necessary with 50% antifreeze
solution. NOTE: Do not remove radiator filler cap if
engine is hot.
Check Tyre Pressures
The tyre pressure should be set at 1 kg/cm
Weekly (every 40 working hours) Weekly (every 40 working hours) Weekly (every 40 working hours) Weekly (every 40 working hours) Weekly (every 40 working hours)
Battery
Check condition of terminals and electrolite level.
Top up as necessary with distilled water
The battery (A Fig.38)is situated under the seat, to
gain access release the seat plate catch (A Fig.37)
and pivot the seat forward and support with the fitted
stay .
Generally check that all nuts, bolts and hydraulic
fittings are tight and retighten where necessary.
Every 100 working hours Every 100 working hours
Every 100 working hours Every 100 working hours Every 100 working hours
Check Belt tensions
Before carrying out any belt adjustments remove the
starter key to prevent the engine from starting (see
starting notes page 26).
See instructions under adjustments page 48 .
Every 200 working hours Every 200 working hours
Every 200 working hours Every 200 working hours Every 200 working hours
Brakes
After placing axle on stand, remove wheel and
inspect brake calipers.
(See also End of Season Servicing).
GB GB GB
GB GB
2
(12 psi)