Table des Matières
Publicité
30
BEFORE THE ENGINE CAN BE STARTED
BEFORE THE ENGINE CAN BE STARTED
BEFORE THE ENGINE CAN BE STARTED
BEFORE THE ENGINE CAN BE STARTED
BEFORE THE ENGINE CAN BE STARTED
1.
Ensure The seat is adjusted correctly for the
operators weight.
2.
Ensure the transmission footpedal is in the
neutral position.
3.
Ensure the cutting unit drive lever is in
neutral.
If any of the above are not set correctly, one of the
LED warnings will illuminate to indicate which control
is incorrectly set. Also the engine will not start.
TO START THE ENGINE
TO START THE ENGINE
TO START THE ENGINE
TO START THE ENGINE
TO START THE ENGINE
Turn the keyswitch to the 'PREHEAT' position,
when the glow plug warning light goes out
continue turning the key to the 'START' position.
When the engine has started, release the key
and allow it to return to the 'ON' position.
IMPORTANT NOTES -
IMPORTANT NOTES -
IMPORTANT NOTES -
IMPORTANT NOTES -
IMPORTANT NOTES -
Always allow the engine to warm up sufficiently
before full load and speed is applied, otherwise the
life of the engine will be shortened.
WARNING NOTES -
WARNING NOTES -
WARNING NOTES -
WARNING NOTES -
WARNING NOTES -
(a) Do not turn key whilst engine is running.
(b) If the engine fails to start within 10 seconds of
switching on, wait for a further 30 seconds
before attempting to start the engine again.
(c)
Do not allow the starter motor to run for more
than 30 seconds, otherwise failure of the
starter motor may result.
TO STOP THE ENGINE
TO STOP THE ENGINE
TO STOP THE ENGINE
TO STOP THE ENGINE
TO STOP THE ENGINE
(a) Return the speed control lever to the "idle"
position.
(b) Switch the key to the "off" position and remove
the key.
TO SLOW DOWN AND STOP THE MACHINE
TO SLOW DOWN AND STOP THE MACHINE
TO SLOW DOWN AND STOP THE MACHINE
TO SLOW DOWN AND STOP THE MACHINE
TO SLOW DOWN AND STOP THE MACHINE
(a) Gradually release the pressure on the foot
pedal to allow the pedal to return to neutral and
the machine will come to a halt.
(b) Disengage the drive to the cutting cylinders by
putting the control lever in the neutral position.
(c)
Apply parking brake.
Publicité
Table des Matières
