Ransomes HIGHWAY 213 VL Série Manuel D'utilisation page 47

46
Fig.23
Fig.24
Fig.25
Fig.26
LUBRICA LUBRICATION LUBRICA TION TION TION
LUBRICA LUBRICA TION
Read the safety instructions
Before starting the engine for the first time lubricate
all points.For recommended lubricants see
specification.
ENGINE ENGINE ENGINE ENGINE ENGINE
Daily (every 8 working hours) Daily (every 8 working hours) Daily (every 8 working hours) Daily (every 8 working hours) Daily (every 8 working hours)
Check level of oil in sump.
Remove dipstick (B Fig.23) and check that the oil is
up to the correct level indicated. If necessary top up
with fresh oil through the filler (A Fig.23) on top of
the rocker box.
NOTE: Ensure the machine is on level ground when
checking the oil level.
After first 50 working hours After first 50 working hours After first 50 working hours After first 50 working hours After first 50 working hours
Change engine oil.
(a) After first warming up the engine remove the
drain plug (A Fig.24)and drain all the oil from
the crankcase sump.
(b) Clean plug and replace.
(c) Remove the filler cap (A Fig.23 and refill with
fresh oil up to the maximum level on the
dipstick (B Fig.23). Capacity 3.1 litres,
(5.5 imp. pints, 6.6 US pints).
(d) Replace filler cap securely.
Every 100 working hours Every 100 working hours Every 100 working hours Every 100 working hours Every 100 working hours
Change engine oil, as quoted under first 50 working
hours.
Every 200 working hours Every 200 working hours Every 200 working hours
Every 200 working hours Every 200 working hours
Change oil filter cartridge
(a) Remove cartridge (A Fig.25) from engine by
unscrewing and discard.
(b) Clean area on crankcase.
(c) Apply a thin film of oil to the gasket and screw
in the new cartridge by hand, securely.
(d) After replacing the new cartridge the engine oil
level will drop, run the engine for a short
period and after ensuring that no leaks
appear, top up with fresh oil to the level
indicated on the dipstick.
MACHINE MACHINE MACHINE
MACHINE MACHINE
Daily (Every 8 working hours) Daily (Every 8 working hours) Daily (Every 8 working hours)
Daily (Every 8 working hours) Daily (Every 8 working hours)
Hydraulic Fluid: Check level of hydraulic oil in the
tank. The level of oil should be maintained
according to the mark indicated beside the
sightglass ( B Fig.26)Top up if necessary with Shell
Tellus 46 to correct level. Access to the hydraulic
oil filler cap is gained by removing four screws from
the left hand tank cover plate (K Fig.15)and
removing it.
GB GB GB
GB GB