Ransomes HIGHWAY 213 VL Série Manuel D'utilisation page 25

Masquer les pouces

Table des Matières

Fig.13

SYSTEM MONITORING INDICATORS (Fig.13)

There are three system monitoring LED's located

next to the key switch. If any one of them is

illuminated the engine will not start. They are as

follows:

1. 1. 1. 1. 1.

Operator presence (D)

Indicated by the seat decal. This LED will be

illuminated if the key switch is turned on and the

operator is not sitting on the seat.

2. 2. 2. 2. 2.

Neutral transmission (E)

Indicated by an 'N' inside a gear wheel decal. This

LED will be illuminated if the traction foot pedal is

not in its neutral position.

3. 3. 3. 3. 3.

Neutral cylinder drive (F)

Indicated by a cutting cylinder and blade decal. This

LED will be illuminated if the cylinder drive lever is

not in its neutral position.

SAFETY AND WARNING INDICATORS (Fig.13)

There are 5 warning lights and 1 blank red lens

located in the switch frame. They are as follows:

1. 1. 1. 1. 1.

Charging warning lamp (G)

Colour red, on when ignition is switched on and will

go out once the engine has started. If the light

comes on while the engine is running, the fan belt

may be slipping or broken or a fault in the electrical

system is indicated and should be investigated.

STOP IMMEDIATELY.

2. 2. 2. 2. 2.

Glow plug indicator lamp (M)

Colour amber, on when the ignition switch is turned

clockwise to the pre-heat position. Once the lamp

goes out the engine can be started.

3. 3. 3. 3. 3.

Engine oil pressure lamp (H)

Colour red, on when ignition is switched on, and will

go out once the engine has started. If the light

comes on when the engine is running - STOP

IMMEDIATELY as this indicates that the oil pressure

is too low. Check the level of oil in the sump and if

necessary top up. Check oil pressure switch.

Continued operation may cause extensive damage

to the engine.

4. 4. 4. 4. 4.

Filter bypass indicator lamp (K)

Colour red, This lamp will come on when the charge

filter becomes blocked and the bypass valve

operates. When this occurs the charge filter should

be changed as soon as possible to avoid damage to

the hydraulic system.

NOTE: Initial start in very cold conditions may result

in the warning lamp being on for a short time.

Table des Matières

Produits Connexes pour Ransomes HIGHWAY 213 VL Série

Ce manuel est également adapté pour:

Highway 213 vk série

Ransomes HIGHWAY 213 VL Série Manuel D'utilisation page 25

Manuels Connexes pour Ransomes HIGHWAY 213 VL Série

Produits Connexes pour Ransomes HIGHWAY 213 VL Série

Ce manuel est également adapté pour:

Table des Matières