Getting Started - Unpacking; Additional Accessories - Evolution R185 SMS Li Notice Originale

the tool, a guard or other part that is damaged
should be carefully checked to determine that it
will operate properly and perform its intended
function - check for alignment of moving parts,
binding of moving parts, breakage of parts,
mounting, and any other conditions that may
affect its operation. A guard or other part that is
damaged should be properly repaired or replaced.
20. Direction of feed. Feed work into a blade
or cutter against the direction of rotation of the
blade or cutter only.
21. Never leave tool running unattended. Turn
power off. Don't leave the tool until it comes to a
complete stop.

GETTING STARTED - UNPACKING

Caution: This packaging contains sharp objects.
Take care when unpacking. This machine could
require two persons to lift, assemble and move
this machine. Remove the machine, together with
the accessories supplied from the packaging.
Check carefully to ensure that the machine is in
good condition and account for all the accessories
listed in this manual. Also make sure that all the
accessories are complete.
If any parts are found to be missing, the machine
and its accessories should be returned together in
their original packaging to the retailer.
Do not throw the packaging away; keep it safe
throughout the warranty period. Dispose of
the packaging in an environmentally
responsible manner. Recycle if possible. Do not let
children play with empty plastic bags due to the
risk of suffocation.
SERIAL NO. / BATCH CODE
The serial number can be found on the motor
housing of the machine. For instructions on how
to identify the batch code, please contact the
Evolution Power Tools helpline or go to:
www.evolutionpowertools.com
www.evolutionpowertools.com

ADDITIONAL ACCESSORIES

In addition to the standard items supplied with
this machine the following accessories are also
available from the Evolution online shop at
www.evolutionpowertools.com or from your
local retailer.
Description
Multi-material TCT
Blade
General wood blade
RECOMMENDED BATTERIES/CHARGERS
Description
2Ah Battery
R18BAT-Li2,
R20BAT-Li2
4Ah Battery R18BAT-Li4,
R20BAT-Li4
5Ah Battery R18BAT-Li5,
R20BAT-Li5
8Ah Battery R18BAT-Li8,
R20BAT-Li8
R18RCH-Li1-
R18RCH-Li1,
Single dock
R20RCH-Li1
charger
R18RCH-Li2 -
R18RCH-Li2,
Double dock
R20RCH-Li2
charger
Note: The use of 2Ah batteries is not recommended
on this machine. Although a 2Ah battery will fit
and run the machine safely, the demand from the
machine may reduce battery life.
If you intend to store a battery for a period without
use then store battery at room temperature (0°C
to 20°C) When storing for very long periods boost
charge the battery once per year to prevent over
discharge. The Ambient temperature range for
tool and battery use: 0°C to 40°C. The charging
temperature: 5°C to 40°C.
10
Part No
RAGEBLADE185MULTI
GW185TCT-24
Part No
EBAT18-Li-2
EBAT18-Li-4,
EHPB18-Li-4
EBAT18-Li-5
EHPB18-Li-8
EFC18-Li
EMC18-Li