Getting Started Unpacking; Items Supplied; Additional Accessories - Evolution EVOSAW185 Instructions D'origine

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

If saw is accidentally dropped, lower guard
may be bent. Raise the lower guard with the
handle and make sure it moves freely and does
not touch the blade or any other part, in all
angles and depths of cut.
i) Check the operation of the lower guard
spring. If the guard and the spring are not
operating properly, they must be serviced
before use. Lower guard may operate
sluggishly due to damaged parts, gummy
deposits, or a build-up of debris.
j) Lower guard may be retracted manually
only for special cuts such as "plunge cuts"
and "compound cuts." Raise lower guard
by retracting handle and as soon as blade
enters the material, the lower guard must
be released. For all other sawing, the lower
guard should operate automatically.
k) Always observe that the lower guard
is covering the blade before placing
saw down on a bench or the floor. An
unprotected, coasting blade will cause the saw
to walk backwards, cutting whatever is in its
path. Be aware of the time it takes for the blade
to stop after switch is released.
(3.4)
WARNING: If any parts are missing, do not
operate your machine until the missing parts
are replaced. Failure to follow this rule could
result in serious personal injury.
GETTING STARTED -
(4.1)
UNPACKING
Caution: This packaging contains sharp
objects. Take care when unpacking. Remove
the machine, together with the accessories
supplied from the packaging. Check carefully
to ensure that the machine is in good
condition and account for all the accessories
listed in this manual. Also make sure that all
the accessories are complete. If any parts
are found to be missing, the machine and its
accessories should be returned together in
their original packaging to the retailer. Do
not throw the packaging away; keep it safe
throughout the warranty period. Dispose
www.evolutionpowertools.com
of the packaging in an environmentally
responsible manner. Recycle if possible.
Do not let children play with empty plastic
bags due to the risk of suffocation.

ITEMS SUPPLIED

(4.2)
Description
Instruction Manual
Steel Cutting Blade
Hex Key 6mm
(Vise Adjustment)
Hex Key 5mm (Blade Change)
Hex Key 3mm
(Upper Blade Guard)
Dust Extraction Port 36mm
Speed Handle
Spare Motor Brushes

ADDITIONAL ACCESSORIES

(4.3)
In addition to the standard items supplied
with this machine, the following accessories
are also available from the Evolution online
shop at www.evolutionpowertools.com or
from your local retailer.
(4.4)
Description
Material specific cutting
blades (use only Evolution
Blades or Evolution approved
blades with this machine)
10
Quantity
1
1
1
1
1
1
1
1 set
Part No
Specific to
blade type

Publicité

Table des Matières
loading

Table des Matières