Fitting And Lowering The Floor-Tool; Fitting The Hose Guide - Numatic TTB 4045/100 Mode D'emploi

Fitting and lowering the Floor Tool
The floor-tool has been designed for quick fitting, allowing easy squeegee blade replacement and a safety knock-off
feature if the floor-tool gets snagged, whilst in transit.
18
19

Fitting the Hose Guide

The vacuum hose has a U-bend clip which creates a U-bend in the hose preventing water spillage when the vacuum
is switched off. If you need to remove the U-bend clip for any reason always ensure it is refitted correctly before you
resume operation.
It is easier to fit the floor-tool if the weight of the machine is resting on the brush. Ensure the brush is fitted first.
Machine Set-Up
Fit the floor-tool and retain using
the detent pin (Fig.18).
The lifting strap is held by a
detent pin (Fig.19).
Raise the floor-tool for transit, lower
for cleaning operation using the
lifting handle fitted to the back of the
machine (Fig.20).
We are now ready to set the controls
to suit the cleaning conditions.
Before any settings can be applied, ensure the brush deck is lowered.
Refit vacuum hose to the Floor-tool when finished.
DO NOT push the vacuum hose onto the Floor-tool with the
Note:
Floor-tool in the raised position.
Note:
26
20
30mm
MAX