Fitting The Floor-Tool; Fitting The Hose Guide - Numatic HT4045 Notice Originale

Fitting the Floor-tool

The floor-tool has been designed for quick fitting, allowing easy squeegee blade replacement and a safety knock-off feature if the floor-
tool gets snagged, whilst in transit.
It is easier to fit the floor-tool if the weight of the machine is resting on the brush. Ensure the brush is fitted first.
9
11

Fitting the Hose Guide

The vacuum hose has a U-bend clip which creates a U-bend in the hose preventing water spillage when the vacuum is switched off. If
you need to remove the U-bend clip for any reason always ensure it is refitted correctly before you resume operation (Fig 12-15).
12
Fit the floor-tool and retain using
the detent pin (Fig.9).
The lifting strap is held by a
detent pin (Fig.10).
Raise the floor-tool for transit or lower for cleaning operation using the lifting handle
fitted to the back of the machine (Fig.11).
For fitting the floor-tool blades (See Page 30).
Raise floor-tool again before driving to the cleaning area.
13
Refit vacuum hose to the Floor-tool when finished.
DO NOT push the vacuum hose onto the Floor-tool with the
Note:
Note:
14
Note:
Floor-tool in the raised position.
Machine Set Up
10
15
T 01460 68600
30mm
MAX
9